Betekenis van:
top side

Voorbeeldzinnen

1. The use of top-side chafers shall be limited to those listed in Annex VIII.
2. The use of top-side chafers shall be limited to those listed in Annex X.
3. Test set-up for dynamic lower legform impactor certification test (side view top diagram, view from above bottom diagram)
4. For some species, except for the front wall, all side walls including the top should be opaque.
5. ‘Third of the bonnet top’ means the geometric trace of the area between the side reference lines, measured with a flexible tape following the outer contour of the bonnet top on any transverse section, divided in three equal parts;
6. Having paid careful attention to all the submissions made by all the interested parties to this proceeding, the investigation has identified that the CRF market is traditionally divided into three segments: the segment of the bottom-mount refrigerators (i.e. fresh-food compartment placed on top of the freezer compartment), the segment of the top-mount refrigerators (i.e. freezer compartment placed on top of the fresh-food compartment) and the segment of the side-by-side refrigerators (i.e. two doors side-by-side opening on two compartments placed side-by-side).
7. It shall, on the right hand side of the top of each page, be marked as ‘original’ and bear a specific code number issued by the competent authority.
8. It shall, on the right hand side of the top of each page, be marked as “original” and bear a specific code number issued by the competent authority.
9. Test set-up for dynamic lower legform impactor certification test (side view top diagram, view from above bottom diagram) Wire length 2,0 m minimum
10. It shall, on the right hand side of the top of each page, be marked as original and bear a specific code number issued by the competent authority.
11. In the case of separate front seats, the rear passengers’ head-impact zone shall extend for 10 cm on either side of the seat centre-line, in the top part of the rear of the seat-back.
12. The sacrum (part No 8a) consists of a mass tuned metal block and a metal plate mounted on top of this block. In the aft side of the block is a cavity to facilitate the application of instrumentation.
13. It is advisable to construct doors and lids, so that the entire top or an entire end or side opens to facilitate cleaning (except in the case of venomous reptiles).
14. two vertical planes K1 I1 F1 E1 and K2 I2 F2 E2 parallel to the reference plane, 250 mm either side of the reference plane, and bounded at the top 300 mm above the plane defined in 1.6.2.7 above;
15. a lateral slope on the side of the railhead angled to between 1/20 and 1/17,2 with reference to the vertical axis of the railhead. The vertical distance between the top of this lateral slope and the top of the rail shall be less than 15 mm;